 |
| Repair & Refurbishment | ||
| Applied Cooling Technology offers a full repair and refurbishment service for most fluid and gas cooled heat exchangers. Heat exchangers require periodic maintenance from cleaning to re-tubing and in the worse case scenario, re-manufacturing. We have a team of fully qualified staff to carry out this work either in our factory or on-site. With nearly 30 years of experience of this work we have encountered most problems associated with old heat exchangers which has led to the development of several patented products and technologies aimed at prolonging the life of heat exchangers. These technologies include:-  Dri-Seal Jiffi-Plug - the safest and most convenient method of plugging failed heat exchanger tubes Dri-Seal Façade Tubeplate Protection System - for cost effective life extension of eroded or corroded heat exchanger tubeplates Dri-Seal Tube Insert - protect the ends of heat exchanger tubes from turbulence induced erosionThese products can be incorporated in initial designs but more often are used during a repair or refurbishment programme to combat corrosion, erosion, stress corrosion cracking etc. | Utilising existing headers, frames and even tubes, with the Dri-Seal Façade Tubeplate Protection System keeps the cost down, but in those instances where the tubes are replaced it is possible to design improvements to the performance with the use of enhancers as well as prolonging the life of the unit. Over 80% of heat exchanger failures occur either at the inlet face of the tube plate or the first 50 to 100mm of the inlet-pass tubes. Tube inserts have been in use for many years in order to stem tube end corrosion. However, the Dri-Seal Façade System has been developed to protect the whole tube plate and tube end area by sealing this vulnerable zone with a unique triple seal system. Experience has show that this system is so effective that even cracked ligaments in the plate are sealed automatically against further leakage. This system utilises a secondary tube plate, backed by a non-porous neoprene gasket joint (to protect the tube plate face). Pre-formed metallic tube inserts with ‘O’ ring seals are used to both protect the tube ends and also to fix the Façade in place. Various materials may be specified depending on the tube-side temperature and chemical, fluid or gas involved. This service can be carried out on-site or at our workshops. |  > Abive: Dri-Seal Facade being fitted |
Home | Products | Technologies | Solutions | Services | Industries | Quality | Contact | About | Sitemap | Linked